-
Notifications
You must be signed in to change notification settings - Fork 113
Disclaimer and Warnings
Joshua Vasquez edited this page Apr 4, 2020
·
2 revisions
Warning! Jubilee requires 120V mains electricity. Working with mains electricity can be dangerous and we are in no way responsible for any form of injury or death related to use of or deviation from these source files and instructions. Also note that, depending on your country of operation, you may be in closer proximity to 220V mains electricity. While Jubilee can be readily adapted to this configuration, there are not instructions listing how to do so at this time.
- Connecting to Jubilee
- Pre-Flight Checks
- Dialing in Parking Post Locations
- Mesh Bed Leveling
- Bed Heater Tuning
- Extruder Heater Tuning
- Setting Tool Offsets
- General Maintenance
- [Tool Plate Disc Replacement]
- [Twist Lock Pin Replacement]
- [Avoiding Loose Screws]
- Bondtech Direct-Drive Extruder
- [E3D Hemera]
- [Passive Pen Tool]
- [Magnetic Bed]
- Flagging Issues
- Adding to the Wiki
- [Adding a Shopping List]
- [Adding a Tool]
- [Adding a Bed Plate]
- Pushing Changes to the Hardware Design
[Acknowledgments]