Bondtech Direct Drive Extruder

This is the default extruder. It's compatible with both an E3D V6 and an E3D Volcano nozzle. This extruder will work with the fabrications specs below with nozzle temps up to 250C and a bed plate temperature up to 80C.

Note: motor heatsinks are not optional! If you operate the motors without heatsinks, the tool plates will warp from the heat. Exposure to radiated heat from the nozzle and the bed is fine up to 80C

Parts to Buy

For a set of two extruders, all parts to buy are called out in this spreadsheet tab.

Assembly Tools

• 1x PTFE Tube Cutter
• 1x E3D Nozzle Spanner Wrench

3D Printed Parts and Settings

Common Settings

• PLA
• 0.4mm nozzle
• No supports
• 0.2mm layer height
• 6 perimters
• 20% infill (any pattern)

Parts and Special Settings

• Blower Fan Shroud
  • Print with support material
• Tool Plate
  • 100% infill (yeup, solid)
• Extruder Holder
• Groovemount Clip
• Left Parking Wing
• Right Parking Wing
• Wedge Plate
  • 0.1mm layer height. This is critical
• Ooze Wiper
• Tool Cable Management Bracket
• Parking Post Base 47mm
• Tool Holder 47mm

Assembly Instructions

• Tool Assembly Instructions
• Parking Post Assembly Instructions