No support interface layers generated #1997
Comments
|
Are not the dense support layers missing below bridges? Do you have the "don't support bridges" option enabled? |
|
"don't support bridges" option is not influencing this behaviour. I oserved this more times when using support enforecer. But not only: here is observed similar issue but without entforcer |
|
Duplicate of #2801 |
|
I have reworked the support generator, so the support enforcers take precedence over "supports on build plate only" and over "dont' support bridges". I have also extended the support generator to trim the support towers by the object silhouette so that for the automatic supports and "supports on build plate only" enabled, the support towers will not land on top of an object, with the drawback of possibly being too tiny / flimsy to be printable.
|
|
|
1) If "support on build plate only" is enabled, the support columns are newly trimmed to not land on top of an object. However this may make the column too small to be stable. 2) Support enforcers newly take precedence over "supports on build plate only" and over "don't support bridges". 3) Some refactoring of the support generator code for clarity: Reduced some of the worst spagetti offenders. Fixes Support generated even if support on build only activated #915 Fixes Bug: supports on build plate only #1340 Fixes Bottom interface layer is not generated , support on build plate only. (long open defect) #4199 Fixes option "supports on build plate only" does not work #3980 Fixes No support interface layers generated #1997 Fixes Feature Request: Option to combine results of 'support from build plate only' and 'support enforcers only' #2801 Fixes Support interface isn't generated: build plate only + blocked by model + support enforcer #3831 Fixes Support Enforcer don't create interface layers #5748 Fixes Support Enforcers Don't Have Top Loops/Raft #1870 Fixes Don't cancel support enforcers with "don't support bridges" #5105
|
Fixed with 9f09f03 |
Just builded your last change to test on my side, |
|
@ProTubeVR As commented elsewhere, the dense support interface is only created below low angled surfaces. The other surfaces are supported sufficiently with the sparse support. Your model is different from the original issue, thus it is a different issue. If you believe this is a problem, then please open a new issue and attach a 3MF so we can test. Thank you. |
Version
1.42b
Operating system type + version
Win7 64bit
3D printer brand / version + firmware version (if known)
MK2.5 MMU2
Behavior
When using support entforcer no support interface layers are generated.
Project File (.3MF) where problem occurs
Transmission_housing.zip
The text was updated successfully, but these errors were encountered: