---

Description:

This is a code example demonstrating FLIR Boson camera command and control using Boson SDK commands. It's written for interface with a Linux system and performs the following commands in sequential order:

• Connects to the camera
• Reads and displays the Camera Serial Number
• Reads and changes the bit depth of the output
• Reads and displays the current Software Revision of the Camera
• Reads and displays the Sensor Part Number
• Reads data from the Camera Flash
• Gets the current Frame Count
• Changes the FFCMode to Manual, then back again
• Performs a manual FFC

---

To compile

First, compile by running

./build.sh

---

To run:

Run example_linux in the examples directory after compiling.

Obtain processor temperature

./examples/boson_cpu_temp

Obtain sensor temperature

./examples/boson_fpa_temp

Run multiple examples

./example_linux

---

Build Notes

This was built on tested with Boson SDK rev 2.0.5. 2.0.5 is included, but the latest SDK can be found at https://www.flir.com/support/products/boson#Resources