[drcachesim] trim trace to avoid staggered attach and detach partial-thread anomalies at ends of trace #2039

derekbruening · 2016-10-20T16:34:00Z

Due to the asynchronous nature of stopping all the threads on detach, some
may run further and produce more data than we'd like for a bursty trace. I
already added a new option -max_trace_size to put a cap on the per-thread
trace size, but we probably also want a way to precisely throw out data
past the detach timestamp.

On the burst-threads test, without the -max_trace_size cap, the secondary
threads produce surprisingly large traces: 65MB, when the start/stop thread
only ran 4 iters of its loop. It may be worth investigating further to
ensure nothing is going wrong there: is it really just a few hundred more
iters that adds up to 65MB??

derekbruening · 2022-09-14T00:01:15Z

This problem occurs on attach as well: the staggered attach means that in an app with thousands of threads the threads taken over early start producing trace data well before the rest of the threads are taken over, resulting in an inaccurate initial picture of the workload.

An alternative to discarding after the fact based on timestamps is to use drbbdup modes to have a non-tracing alternative mode. Only once attach has taken over all threads would we flip a switch and have the tracing mode start, simultaneously in all threads. We would use a load-acquire read of the mode flag which is fairly performant.

While this is more overhead than fixing up later, it fits well with schemes that pre-populate the code cache in a lower-overhead no-tracing mode before starting tracing.

There are two ways to trigger the mode switches for statically linked drmemtrace: new DR events for post-attach and pre-detach, or annotations. Annotations are more flexible as when pre-populating the tool can separate attach from tracing.

We would want to implement annotations for aarchxx #1672, and solve the raw2trace issues with annotations #4141.

Adds two new DR events: post-attach and pre-detach. These help tools align instrumentation with points where all threads are under DR control, avoiding uneven thread execution during the incremental staggered attach and detach processes. Adds some sanity tests that the events are called where they should be. Adding them to drmemtrace will be done separately. Issue: #2039

Adds two new DR events: post-attach and pre-detach. These help tools align instrumentation with points where all threads are under DR control, avoiding uneven thread execution during the incremental staggered attach and detach processes. Adds some sanity tests that the events are called where they should be, for both internal and external attach. Adding them to drmemtrace will be done separately. Issue: #2039

Adds support for multiple app copies in rseq mangling finalization's search for labels to fill in code cache PC's. Adds support for multiple rseq regions in one fragment_t by expanding the stored rseq_cs per fragment to become a list. Adds "-trace_after_instrs 5K" to the tool.drcacheoff.rseq test to exercise rseq with drbbdup. Augments the attach/detach api.rseq test to use drmemtrace, which with the forthcoming #2039 mode switches also hits this multi-rseq case. Fixes #5659

Fixes PR #5663 which fixed drreg restoration for drbbdup but broke it for non-drbbdup. bb->instr was NULL so the preinsert was an append, and the label as the last instruction moved the drreg restore point to after the native sequence! Here, we explicitly append to avoid confusion, and we move the native sequence to the point of the barrier instead of at the final app instr, which is where the registers are actually native. Tested on larger apps using rseq which reliably crashed without this fix. This fix also seems to fully fix drbbdup usage with drmemtrace for #2039. Issue: #5658, #2039

Adds drmemtrace_replace_file_ex_ops() with an expanded file opening function which takes in the thread id and window id, to better support the external file opener with delayed opens due to nop mode and windows. Adds a test of the function to burst_replaceall. Adds additional threads to the test and checks that the tid for each thread was seen. Issue: #2039

Adds drmemtrace_replace_file_ex_ops() with an expanded file opening function which takes in the thread id and window id, to better support the external file opener with delayed opens due to nop mode and windows. The new function takes in a struct to make it easier to extend further in the future. Adds a test of the function to burst_replaceall. Adds additional threads to the test and checks that the tid for each thread was seen, but disables that part on Windows due to #2040. Issue: #2039

Adds a new drbbdup mode to drmemtrace which performs zero instrumentation (except drwrap cleanup). This mode is used when attaching for the period prior to full control of all threads and when detaching prior to starting to let threads go native, to avoid uneven thread instrumentation during these incremental staggered processes. The mode is initially under an off-by-default new option -align_endpoints while drbbdup stability is being worked on (i#5686). Threads that did nothing during the trace-mode period are now omitted from the trace. Adds a test by adding 4 idle threads to burst_threads and ensuring they do not show up in the trace. Alignment itself was tested manually by running larger applications and analyzing the timestamp ranges in the trace. Fixes the burst_replace test to work properly with .zip output (the output regex still matched despite a printed error from raw2trace, it seems). Timestamps during detach require further work as they inaccurately imply executing after tracing mode was turned off. The next part will address this issue. Issue: #2039, #5686

Moves the timestamp+cpu headers to be added at buffer creation time instead of at buffer output time. Makes instru_t::frozen_timestamp_ use release-acquire semantics and sets it for -align_endpoints at detach time. Adds a 'minimum timestamp' recorded at post-attach time. At buffer output time, we examine the buffer's timestamp and if it was from before the minimum, we replace it with the current (not the minimum) timestamp. Tested on a large app where these changes result in much tighter timestamps matching the burst period. Issue: #2039

derekbruening · 2022-10-27T20:13:47Z

From #5704 (comment): we should add an invariant check that timestamps always increase monotonically through each trace.

Moves the timestamp+cpu headers to be added at buffer creation time instead of at buffer output time. Makes instru_t::frozen_timestamp_ use release-acquire semantics and sets it for -align_endpoints at detach time. Adds a 'minimum timestamp' recorded at post-attach time. At buffer output time, we examine the buffer's timestamp and if it was from before the minimum, we replace it with the minimum. Tested on a large app where these changes result in much tighter timestamps matching the burst period. This also directly fixes #5537 which pointed out that the timestamps being at buffer output time is contradicted by the documentation. Issue: #2039, #5537 Fixes #5537

Part 4 added a minimum timestamp, but it only works for data that is not actually emitted until we are fully attached. For data emitted before that point, we'll use a too-early timestamp. We solve that here by dropping such data. Tested on a large app where these changes solve gaps at the start of the trace due to an early timestamp in one thread. Issue: #2039

Since the stability issues with drbbdup on larger apps seem limited to x86, we enable -align_endpoints by default for AArchXX. Issue: #2039

Part 4 added a minimum timestamp, but it only works for data that is not actually emitted until we are fully attached. For data emitted before that point, we'll use a too-early timestamp. We solve that here by dropping such data. It is not easy to make an automated test unfortunately. Issue: #2039

Since the stability issues with drbbdup on larger apps seem limited to x86, we enable -align_endpoints by default for AArchXX. This revealed a drbbdup issue on AArch64: OP_isb must end a bb. Added this to drbbdup's list of special opcodes, and to the bb event docs where it was missing. This fixes drcacheoff.gencode test failures. Adds more synch to the burst_replaceall test to ensure all threads are scheduled to avoid empty threads which mess up the expected output with -align_endpoints. Relaxes the burst_threadfilter template to allow empty unscheduled threads. Relaxes the burst_replace template to allow lazy file opening. Issue: #2039

Fixes an issue with refreshing the timestamp when filtering is on where the first (extended) header flag was cleared on a filter-discarded buffer. Tested by running "ctest -V --repeat-until-fail 100 -R burst_threadL0filter". Previously it failed on the 3rd test; now all 100 pass. Issue: #2039

Fixes an issue with refreshing the timestamp when filtering is on where the first (extended) header flag was cleared on a filter-discarded buffer. Tested by running "ctest -V --repeat-until-fail 100 -R burst_threadL0filter". Previously it failed on the 3rd test; now all 100 pass. Fixes #5774 Issue: #2039, #5774

With the stability issues with drbbdup seemingly solved, we enable -align_endpoints by default for x86 (it was already on for AArchXX). Fixes #2039

derekbruening added Type-Feature Component-DRTool labels Oct 20, 2016

derekbruening self-assigned this Oct 20, 2016

derekbruening added the Component-DrMemtrace label Oct 30, 2018

derekbruening changed the title ~~[drcachesim] add detach timestamp to trace and discard data past that point~~ [drcachesim] trim trace to avoid staggered attach and detach partial-thread anomalies at ends of trace Sep 14, 2022

derekbruening mentioned this issue Sep 16, 2022

i#2039 trace trim, part 1: Add post-attach and pre-detach events #5653

Merged

derekbruening mentioned this issue Sep 26, 2022

i#5659: Handle multiple app copies in rseq mangling #5660

Merged

derekbruening mentioned this issue Sep 30, 2022

i#5658 rseq drreg: Put native sequence by barrier #5664

Merged

derekbruening mentioned this issue Oct 7, 2022

i#2039 trace trim, part 2: Add open_file with tid #5679

Merged

derekbruening mentioned this issue Oct 17, 2022

drbbdup fails to restore state for its register spills #5686

Open

derekbruening mentioned this issue Oct 25, 2022

i#2039 trace trim, part 3: Add nop mode to drmemtrace #5700

Merged

derekbruening mentioned this issue Oct 25, 2022

i#2039 trace trim, part 4: Clamp timestamps #5704

Merged

derekbruening mentioned this issue Oct 27, 2022

drmemtrace timestamp and cpu_id are documented as before but are really after their buffer contents #5537

Closed

derekbruening mentioned this issue Nov 30, 2022

i#2039 trace trim, part 5: Drop early data #5768

Merged

derekbruening added a commit that referenced this issue Dec 1, 2022

i#2039 trace trim, part 6: Enable for AArchXX

1ce1bf4

Since the stability issues with drbbdup on larger apps seem limited to x86, we enable -align_endpoints by default for AArchXX. Issue: #2039

derekbruening mentioned this issue Dec 1, 2022

i#2039 trace trim, part 6: Enable for AArchXX #5770

Merged

derekbruening mentioned this issue Dec 2, 2022

i#2039 trace trim, part 7: Fix filtered refresh #5775

Merged

derekbruening added a commit that referenced this issue Jan 20, 2023

i#2039 trace trim, part 8: Enable for x86

fe13caa

With the stability issues with drbbdup seemingly solved, we enable -align_endpoints by default for x86 (it was already on for AArchXX). Fixes #2039

derekbruening mentioned this issue Jan 20, 2023

i#2039 trace trim, part 8: Enable for x86 #5832

Merged

derekbruening closed this as completed in #5832 Jan 21, 2023

derekbruening added a commit that referenced this issue Jan 21, 2023

i#2039 trace trim, part 8: Enable for x86 (#5832)

4e7437f

With the stability issues with drbbdup seemingly solved, we enable -align_endpoints by default for x86 (it was already on for AArchXX). Fixes #2039

dolanzhao pushed a commit that referenced this issue Jan 30, 2023

i#2039 trace trim, part 8: Enable for x86 (#5832)

87446f4

With the stability issues with drbbdup seemingly solved, we enable -align_endpoints by default for x86 (it was already on for AArchXX). Fixes #2039

ivankyluk mentioned this issue May 10, 2023

Add timestamp marker increase monotonically invariant check. #6037

Closed

ivankyluk mentioned this issue Jul 6, 2023

Add invariant check that timestamps always increase monotonically #6187

Closed

derekbruening mentioned this issue Mar 30, 2024

drmemtrace -trace_after_instrs introduces gap between first and second timestamps #6745

Closed

Provide feedback

Saved searches

Use saved searches to filter your results more quickly

[drcachesim] trim trace to avoid staggered attach and detach partial-thread anomalies at ends of trace #2039

[drcachesim] trim trace to avoid staggered attach and detach partial-thread anomalies at ends of trace #2039

derekbruening commented Oct 20, 2016

derekbruening commented Sep 14, 2022 •

edited

Loading

derekbruening commented Oct 27, 2022

[drcachesim] trim trace to avoid staggered attach and detach partial-thread anomalies at ends of trace #2039

[drcachesim] trim trace to avoid staggered attach and detach partial-thread anomalies at ends of trace #2039

Comments

derekbruening commented Oct 20, 2016

derekbruening commented Sep 14, 2022 • edited Loading

derekbruening commented Oct 27, 2022

derekbruening commented Sep 14, 2022 •

edited

Loading