Skip to content

Latest commit

 

History

History
43 lines (28 loc) · 1.73 KB

build-guide-r2-assembly.md

File metadata and controls

43 lines (28 loc) · 1.73 KB

0-Sixty R2: Case Assembly Guide

This assembly guide assumes that you have already prepared the PCB and soldered all necessary components according to this guide.

Tools required

  1. M3 allen wrench (included)
  2. Philips screw driver

Assembly:

Step 1

  1. Unscrew the top-most layer, and peel away the brown protective stickers from both sides.
  2. Reinstall this top layer, along with all the screws.

Step 2

  1. Unscrew the bottom layer, peel away the protective sticker, and set this piece of transparent acrylic aside for now.

  2. Carefully pry out the last (bottom-most, black) acrylic layer.

  3. Screw in your prepared PCB into the 4 brass screw holes at the corners. A couple points:

    • The included white nylon philips screws will be used here.
    • Don't worry if this layer flexes a bit as you put in all the screws.

  4. Carefully snap the black acrylic layer back into its original place.

  5. Install back the last transparent layer.

Voila! Your 0-Sixty is ready for use.

Optional

  1. Apply the provided silicone bump-ons at the bottom.
  2. Use the angle-adjusment block with the provided silver philips screws. These are attached to one of the 2 pairs of brass screw holes at the bottom layer. Try out the 2 possible screw locations and find the angle that suits you best.