[device/celestica]: libsensors configuration file for Seastone-DX010

[mudsut4ke]

- What I did

• Update sensor configuration file follow thermal specification document

- How I did it

1. Update lm75b sensor threshold

- How to verify it

• Run command sensors under sonic and check lm75b sensor threshold

Signed-off-by: Wirut Getbamrung [email protected]

[mudsut4ke]

@yxieca , this PR refer to sensor alarm issue on Seastone-DX010

[yxieca]

@mudsut4ke While your change might be addressing other issues. It didn't address the test failure fully. Looks like the ASIC max_hyst is default set to 28 and the temperature reading is 37, which is higher than the max_hyst. Can you propose another change and test it before posting it?

        "temp_reasons": [
            "Alarm on lm75b-i2c-7-4a/ASIC temp sensor/temp1_input"
        ]
        "lm75b-i2c-7-4a": {
            "ASIC temp sensor": {
                "temp1_input": "37.000", 
                "temp1_max": "70.000", 
                "temp1_max_hyst": "28.000"
            }
        }

[yxieca]

Didn't fully address the observed test failure.

[mudsut4ke]

@yxieca , temp1_max_hyst was set to 28 because of old sensor config,
Anyway I have added 5 °C hysteresis temperature follow default value in lm75 datasheet to avoid the issue.

admin@sonic:~$ sensors -u lm75b-*
lm75b-i2c-14-48
Adapter: i2c-0-mux (chan_id 4)
Rear-panel temp sensor 1:
  temp1_input: 33.250
  temp1_max: 50.000
  temp1_max_hyst: 45.000

lm75b-i2c-6-49
Adapter: i2c-0-mux (chan_id 4)
Front-panel temp1 sensor 2:
  temp1_input: 36.500
  temp1_max: 50.000
  temp1_max_hyst: 45.000

lm75b-i2c-15-4e
Adapter: i2c-0-mux (chan_id 5)
Rear-panel temp1 sensor 2:
  temp1_input: 32.000
  temp1_max: 70.000
  temp1_max_hyst: 65.000

lm75b-i2c-7-4a
Adapter: i2c-0-mux (chan_id 5)
ASIC temp1 sensor:
  temp1_input: 42.875
  temp1_max: 70.000
  temp1_max_hyst: 65.000

lm75b-i2c-5-48
Adapter: i2c-0-mux (chan_id 3)
Rear-panel temp sensor 1:
  temp1_input: 34.000
  temp1_max: 50.000
  temp1_max_hyst: 45.000

admin@sonic:~$