Update readme.md

keyboards/handwired/zeropad/readme.md

@@ -1,28 +1,30 @@
-#ZeroPad
+# ZeroPad
 
 ZeroPad:
 ![ZeroPad](https://github.com/user-attachments/assets/224aa55a-045b-4bb9-b6e9-34f092ced5c4)
 
 
 *This keyboard is inspired by the scotto9 from Joe Scotto. This keyboard is compatible with via and has 4 layers of keybinds (24 keybinds - 4x8 + 1 per layer for changing the layer).*
-* Keyboard Maintainer: [Leons Sieber](https://github.com/diffrentGuesser)
-* Hardware Supported: *The PCBs, controllers supported*
-* Hardware Availability: *Links to where you can find this hardware*
+* Keyboard Maintainer: [Leon Sieber](https://github.com/diffrentGuesser)
+* Hardware Supported: Pro Micro, 3 pin switches
+* Hardware Availability: [Pro Micro](https://de.aliexpress.com/item/32846843498.html?spm=a2g0o.cart.0.0.146d4ae4kCjqDY&mp=1&gatewayAdapt=glo2deu), [switches](https://de.aliexpress.com/item/1005007135709029.html?spm=a2g0o.cart.0.0.146d4ae4kCjqDY&mp=1&gatewayAdapt=glo2deu)
 
 Make example for this keyboard (after setting up your build environment):
 
-    make %KEYBOARD%:default
+    make handwired/zeropad:default
+
 
 Flashing example for this keyboard:
 
-    make %KEYBOARD%:default:flash
+    make handwired/zeropad:default:flash
+
 
 See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
 
 ## Bootloader
 
-Enter the bootloader in 3 ways:
+Enter the bootloader:
 
-* **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
-* **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
-* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available
+* **Physical short**: Short the GND and the RST pins to flash the keyboard new.
+  * This will put the board into bootloader mode, allowing you to flash a new firmware.
+  * Make sure you disconnect and reconnect the cable after shorting the pins.