Last wipe sequence of a print happens in the air

[gbzh01]

2.2.0+
PrusaSlicer-2.2.0+-202003211132

Operating System: Macintosh
System Architecture: 64 bit
System Version: macOS Mojave Version 10.14.6 (Build 18G4032)
Total RAM size [MB]: 17,180MB

Prusa MK3s Multimaterial
FW: 3.8.1
MM FW: 1.0.6

Behavior

• Describe the problem
  Multimaterial print: At the end of the print, the nozzle prints the last wipe sequence in the air. It can also be seen in PrusaSlicer

• Steps needed to reproduce the problem
  Import a file and do a color change with the height bar adjustment in PrusaSlicer

  • If this is a command-line slicing issue, include the options used

• Expected Results
  The last wipe sequence should be on the wipe tower. Expect that the nozzle travels down to the wipe tower again

• Actual Results
  The nozzle stays on the hight of the object, disregarding the height of the wipe tower

  • Screenshots from PrusaSlicer preview are preferred
    Attached
    

Is this a new feature request?
No

[rtyr]

This is intentional. Please read the FAQ. #3533, #3116, #2412, #1355, #2088, #1616, #1070, #1268, #1423, #1386, #663, #1581, #2612. Closing.