MMU2 Purge block mid air lines

[Petclaud]

Version

1.41.2

Operating system type + version

W10

Behavior

Sliced a 2 color model
Purge block is in 3D view just as high as the entire model while there should not be any color changes after z-height 24.8
In the Preview tab, the purge tower stops at the expected z-height, however a small line purge block line also exists mid air at the top height of the model ...?

• Steps needed to reproduce the problem
  Slice attached model

• Expected Results
  purge block in 3D view and Preview tab to be the same height
  no mid air lines for the purge block in Preview tab

Is this a new feature request?
no

Biobank individual models.zip

biobank 12.5 jaar (10)_0.2mm_PLA_MK3MMU2.gcode.zip

[lukasmatena]

This is the intended and desired behavior, repeatedly discussed in issues such as #1355, #1386, #1070, #663 and possibly others.

Closing.

[Petclaud]

Thank you very much for the quick feedback. Sorry I missed out that this was addressed before.