2.2.0-RC5 Does not slice

[Grogyan]

Version

2.2.0-RC5

Operating system type + version

What OS are you using, and state any version #s
Windows 10

3D printer brand / version + firmware version (if knownn

Generic RepRap I3 MK2.5 Running Marlin 2

Behavior

• Describe the problem
  Slicing a model results in no sliced gcode.

• Steps needed to reproduce the problem
  Using a fresh clean copy of PrusaSlicer 2.2.0-RC5
  Ensure Virus Scanner is disabled, or allow PrusSlicer access to write data to computer
  Update Printer profile, including start and end gcode
  Load in a 3D Benchy, which has been mesh fixed using Windows Builder, saved in .3mf
  Slice model
  No gcode generated at all

• Expected Results
  Load in a model, 3D Benchy in this case.
  Slice
  Gcode generated for printing

• Actual Results
  No Gcode is generated

PrusaSlicer_config_bundle.zip

[Grogyan]

No Errors were provided.

Restarted PS 2.2.0-RC5 multiple times
Still no errors.

Error presented after restarting over 10x of PS2.2.0-RC5 of initial layer higher cannot exceed nozzle diameter
Which showed that PS2.2.0-RC5 did not automatically adjust or notify me of this parameter when the settings were saved, as the nozzle diameter was changed from 0.4mm to 0.3mm

[bubnikv]

So you expect the install wizard to adjust the numbers or give you a warning? If you follow the error message, is your problem solved? so 21. 3. 2020 v 3:07 odesílatel Grogyan <[email protected]> napsal:

…

No Errors were provided. Restarted PS 2.2.0-RC5 multiple times Still no errors. Error presented after restarting over 10x of PS2.2.0-RC5 of initial layer higher cannot exceed nozzle diameter Which showed that PS2.2.0-RC5 did not automatically adjust or notify me of this parameter when the settings were saved, as the nozzle diameter was changed from 0.4mm to 0.3mm — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#3876 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABMPSI5OTWHTU4VBSYUFQ3DRIQONNANCNFSM4LQX3PMA> .

[Grogyan]

I would expect an error to be produced.

As stated, no error came up
Not even restarting PrusaSlicer 2.2.0-RC5 several times.

About an hour later I did get an error popup.
I would say that the problem isn't solved, if no error pop up comes up for an hour.

But it should be a warning, not an error, for "Initial layer must be less than nozzle diameter"

Now looking at the first Benchy print with the same settings as I use on Cura, and it is awful.
There is certainly some weird stuff occurring during print. But that is a separate problem, that haven't yet located the source of the problem.

[rtyr]

I tried your settings in 2.2.0 final. Error message is produced correctly, so I believe it si fixed. Closing.