Update mbed docs

docs/guides/mbedos_commissioning.md

@@ -209,7 +209,7 @@ To build and install the Python Device Controller application check the guide
 In order to send commands to a device, it must be paired with the client and
 connected to the network.
 
-To run the commissioning process via BLE:
+To run the auto commissioning process via BLE:
 
 -   Run Device Controller:
 
@@ -219,27 +219,14 @@ To run the commissioning process via BLE:
 
         chip-device-ctrl > ble-scan
 
--   Connect the device via BLE (provide the accessory device discriminator,
-    setup pin code and node ID):
-
-        chip-device-ctrl > connect -ble 3840 20202021 1234
-
 -   Pass the Wi-Fi credentials to the device:
 
-        chip-device-ctrl > zcl NetworkCommissioning AddOrUpdateWiFiNetwork 1234 0 0 ssid=str:TESTSSID credentials=str:P455W4RD breadcrumb=0 timeoutMs=1000
-
--   Enable the Wi-Fi interface:
+        chip-device-ctrl > set-pairing-wifi-credential ssid credentials
 
-        chip-device-ctrl > zcl NetworkCommissioning ConnectNetwork 1234 0 0 networkID=str:TESTSSID breadcrumb=0 timeoutMs=1000
-
--   Close BLE connection:
-
-        chip-device-ctrl > zcl NetworkCommissioning ConnectNetwork 1234 0 0 networkID=str:TESTSSID breadcrumb=0 timeoutMs=1000
-
--   Discover IP address of the device (address is cached in the controller for
-    later usage). You should provide the fabric and node ID:
+-   Connect the device via BLE (provide the accessory device discriminator,
+    setup pin code and node ID):
 
-        chip-device-ctrl > resolve 5544332211 1234
+        chip-device-ctrl > connect -ble 3840 20202021 1234
 
 ## Sending ZCL commands
 

examples/lighting-app/mbed/README.md

@@ -334,8 +334,8 @@ The following states are possible:
     procedure. **LEDs 1-4** blink in unison when the factory reset procedure is
     initiated.
 
--   _Pressed for less than 3 s_ — Initiates the OTA software update
-    process. This feature is not currently supported.
+-   _Pressed for less than 3 s_ — Delete all fabric IDs and start BLE
+    advertising.
 
 **Button 1** — Pressing the button once changes the lighting state to the
 opposite one.

examples/lock-app/mbed/README.md

@@ -322,8 +322,8 @@ possible:
     procedure. **LEDs 1-4** blink in unison when the factory reset procedure is
     initiated.
 
--   _Pressed for less than 3 s_ — Initiates the OTA software update
-    process. This feature is not currently supported.
+-   _Pressed for less than 3 s_ — Delete all fabric IDs and start BLE
+    advertising
 
 **Button 1** — Pressing the button once changes the lock state to the
 opposite one.