Can't configure after install #346
-
|
Fresh install of HA. I installed HACS, then followed the Tapo Controller install instructions by searching for Tapo Controller on HACS. It loads the Tapo Controller page that mirrors github. I hit download. HACS acknowledges the change and requires restart. After restart I go back to HACS and Tapo Controller is listed. When I click on Tapo Controller it opens the same GitHub readme page with the instructions. No configure options at all. The instructions state at this point I should have an option to input the device information but I can't figure out where that is. When I hit the three dots at the top it gives me the normal options, with the option to redownload or remove. So it thinks it is installed. Am I completely blind? Where can I find my devices/configure the integration? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
Read through the manual way and didn't realize that it also needed to be added in Settings > Devices > + add integration > search for Tapo Perhaps this should be added to the "install with HACS" section of the readme as it is only mentioned in the manual install section. Completely new to HA so I didn't know that step would be needed when installing with HACS too. |
Beta Was this translation helpful? Give feedback.
Read through the manual way and didn't realize that it also needed to be added in Settings > Devices > + add integration > search for Tapo
Perhaps this should be added to the "install with HACS" section of the readme as it is only mentioned in the manual install section. Completely new to HA so I didn't know that step would be needed when installing with HACS too.