Add new kstat for monitoring time in dmu_tx_assign #1584
Closed
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
This change adds a new kstat to gain some visibility into the amount of
time spent in each call to dmu_tx_assign. A histogram is exported via
a new dmu_tx_assign_histogram-$POOLNAME file. The information contained
in this histogram is the frequency dmu_tx_assign took to complete given
an interval range. For example, given the below histogram file:
one can see most calls to dmu_tx_assign completed in 32us or less, but a
few outliers did not. Specifically, 4 of the calls took between 262144us
and 131072us. This information is difficult, if not impossible, to gather
without this change.
Signed-off-by: Prakash Surya [email protected]