Marlin Legacy or 2?

[Pridanc]

Hey everyone. Although I tend to use CURA because that was my first slicer, I've started to us ORCA for some other things. Along the way ORCA is asking which version of Marlin I use. The default here is "Marlin Legacy" but there is an option for "Marlin 2". Which should I use or does it matter? My Ender has a new SKR Mini 3 v3 board and flashed with Mriscoc as my firmware.

[mriscoc]

The Professional Firmware is based on the latest Marlin.

[Pridanc]

​Price Cobb Confidentiality Statement & Notice: This email is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521 and intended only for the use of the individual or entity to whom it is addressed. Any review, retransmission, dissemination to unauthorized persons or other use of the original message and any attachments is strictly prohibited. If you received this electronic transmission in error, please reply to the above-referenced sender about the error and permanently delete this message. Thank you for your cooperation. Sent from Proton Mail Android

…

-------- Original Message --------

On 5/4/24 12:04 AM, Miguel Risco-Castillo wrote: The Professional Firmware is based on the latest Marlin. — Reply to this email directly, [view it on GitHub](#1299 (comment)), or [unsubscribe](https://github.com/notifications/unsubscribe-auth/A6S6WCEACWRFCQTQWQYTD6LZART7NAVCNFSM6AAAAABHGC5UAKVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4TGMJRGM4DA). You are receiving this because you authored the thread.Message ID: ***@***.***>