Duo-V1.0.7
Change log V1.0.7
- Support Duo 256M.
- Duo/Duo256M option added to compile script, see the README or official documentation.
- Integrated camera rtsp push streaming test program, more information here.
Known Issues
- Duo 256M does not yet support wiringX and pinpong library.
The firmware introduction:
- Enable ssh
- Enable RNDIS
- Blink LED
- Root password: milkv
Login via RNDIS using ssh:
If you want to disable LED blinking:
mv /mnt/system/blink.sh /mnt/system/blink.sh_backup && sync
then reboot the board.
Use the IO-Board
Note that when using the IO-Board, the USB network (RNDIS) is not available, Please use the Ethernet interface on the IO-Board.
If you need to assign a fixed MAC address to the Ethernet port of the IO-Board, please execute the following command(Replace the MAC address in the command with the MAC address you want to set, and please note that MAC addresses of different devices within the same network segment must not be duplicated).
echo "pre-up ifconfig eth0 hw ether 78:01:B3:FC:E8:55" >> /etc/network/interfaces && sync
then reboot the board.
Enable the 4 USB ports on the IO-Board:
rm /mnt/system/usb.sh
ln -s /mnt/system/usb-host.sh /mnt/system/usb.sh
sync
then reboot the board.
Restore the USB network (RNDIS) when the IO-Board is not used:
rm /mnt/system/usb.sh
ln -s /mnt/system/usb-rndis.sh /mnt/system/usb.sh
sync
then reboot the board.