This is a tool using the CaDiCaL solver to determine the backbone of a satisfiable instance, which are those literals set to true in all models of the formula.
You need to get and compile CaDiCaL in the same directory in which you have the CaDiBack sources, i.e., before configuring and compiling it make sure to have
../cadical/build/libcadical.a../cadical/src/cadical.hpp
Then issue ./configure && make to configure and compile it. To also test
the library you also use make test (additionally or alternatively). There
are further configuration options which can be listed with ./configure -h.
Usage of the tool is as follows. Given the following CNF in dimacs.cnf
calling cadiback on it it will give:
$ cat dimacs.cnf
p cnf 3 4
1 2 0
1 -2 0
2 -3 0
-2 -3 0
$ cadiback -q dimacs.cnf
b 1
b -3
b 0
s SATISFIABLE
This example shows that exactly the two literals 1 and -3 are backbones
and that there are models both with 2 and -2, i.e., the variable 2 is
not a backbone variable. In general the tool can produce multiple b lines
which are not ordered and can be interleaved with comment lines starting
with c. After the extractor found all backbones it prints the b 0 line.
The backbones are printed as they are found and the output is flushed
whenever a new backbone is found. This allows to use the tool in an
any-time fashion. Without the -q option more comment lines are printed
before, between and after the backbone section, and with higher verbosity or
reporting enabled even in between 'b' lines. If the given CNF is
unsatisfiable the extractor prints 's UNSATISFIABLE' instead at the end.