net: libwx: fix firmware mailbox abnormal return

The existing SW-FW interaction flow on the driver is wrong. Follow this
wrong flow, driver would never return error if there is a unknown command.
Since firmware writes back 'firmware ready' and 'unknown command' in the
mailbox message if there is an unknown command sent by driver. So reading
'firmware ready' does not timeout. Then driver would mistakenly believe
that the interaction has completed successfully.

It tends to happen with the use of custom firmware. Move the check for
'unknown command' out of the poll timeout for 'firmware ready'. And adjust
the debug log so that mailbox messages are always printed when commands
timeout.

Fixes: 1efa9bf ("net: libwx: Implement interaction with firmware")
Signed-off-by: Jiawen Wu <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Jakub Kicinski <[email protected]>

drivers/net/ethernet/wangxun/libwx/wx_hw.c

@@ -334,27 +334,25 @@ int wx_host_interface_command(struct wx *wx, u32 *buffer,
 	status = read_poll_timeout(rd32, hicr, hicr & WX_MNG_MBOX_CTL_FWRDY, 1000,
 				   timeout * 1000, false, wx, WX_MNG_MBOX_CTL);
 
+	buf[0] = rd32(wx, WX_MNG_MBOX);
+	if ((buf[0] & 0xff0000) >> 16 == 0x80) {
+		wx_err(wx, "Unknown FW command: 0x%x\n", buffer[0] & 0xff);
+		status = -EINVAL;
+		goto rel_out;
+	}
+
 	/* Check command completion */
 	if (status) {
-		wx_dbg(wx, "Command has failed with no status valid.\n");
-
-		buf[0] = rd32(wx, WX_MNG_MBOX);
-		if ((buffer[0] & 0xff) != (~buf[0] >> 24)) {
-			status = -EINVAL;
-			goto rel_out;
-		}
-		if ((buf[0] & 0xff0000) >> 16 == 0x80) {
-			wx_dbg(wx, "It's unknown cmd.\n");
-			status = -EINVAL;
-			goto rel_out;
-		}
-
+		wx_err(wx, "Command has failed with no status valid.\n");
 		wx_dbg(wx, "write value:\n");
 		for (i = 0; i < dword_len; i++)
 			wx_dbg(wx, "%x ", buffer[i]);
 		wx_dbg(wx, "read value:\n");
 		for (i = 0; i < dword_len; i++)
 			wx_dbg(wx, "%x ", buf[i]);
+		wx_dbg(wx, "\ncheck: %x %x\n", buffer[0] & 0xff, ~buf[0] >> 24);
+
+		goto rel_out;
 	}
 
 	if (!return_data)