Change Filament Runout pin to the Z endstop Sidewinder X2

[Clankcoll]

Requirements

On physical printer you will need to unplug your filament sensor from the lower connector and take the long wire out that goes down the left Z axis Bar. This will need to be routed exactly the same way except down the right Z axis bar.
the lower connector will plug directly in to the open plug on the lower right side (black connector that went to the original Z stop for the X1) make sure when you plug this in that the brown/blue/black wires correspond to the wires in the harness, This plug is capable of being plugged in backwards and it will not work.

Benefits

Usability enables the use of the Filament Runout Sensor with e.g. Ocotoprint

Related Issues

(Maybe i didnt look through)

Configuration.zip

[freakydude]

Hi,

thank your pull request.

I was pretty sure this line was already added ... but it wasn't. Did you test it? Did it work?

Greetings

[freakydude]

Found it,
i added it directly to Marlin/src/pins/stm32f4/pins_ARTILLERY_RUBY.h.

But you are right.
I merged it and will remove the previous line together with the newest Marlin 2.1.2.1 release.

Thank you