-
Notifications
You must be signed in to change notification settings - Fork 2
Building your own
demik edited this page Aug 4, 2022
·
4 revisions
This project OpenSource, any advanced user may want to build their own board from scratch. The board is mostly SMD, with a few through hole components.
The recommended way is to get the SMD assembly done by your favorite PCB printer and add the through hole components by yourself. I'm using JLBPCB for this project but there isn't anything specific so you may want to use your favorite one.
- The gerber archive is located in the 1.4.0 release (Quack_14_PCB.zip)
- The SMD BOM and placement files are located in the EDA/SMT subfolder
A few components has been tested with the board, you can fin them on the following table:
| Connector | Brand | P/N | Notes |
|---|---|---|---|
| ADB | Lumberg | TM 0508 A/4 | |
| ADB | TE Connectivity | 5749263-1 | Nickel |
| ADB | TE Connectivity | 5749181-1 | Gold |
| Quadrature | TE Connectivity | 2301843-1 | |
| Quadrature | TRU Components | TC-6648084 |
You also need a 2.54mm 4 pin header and an 3 positions, Off/On, DIP switch. If it helps, here is a Mouser Link
Once assembled, the next step is to flash the board