Chromaduino

A driver for a (slave) Funduino/Colorduino 8x8 RGB LED board. The LED display can then be controlled by an I2C master.

A driver for a Funduino/Colorduino (slave) board:

• an 8x8 RGB LED matrix common anode
• an ATMEGA328P connected to
  • a DM163 which drives 24 channels of PWM data connected to 8x Red, Green and Blue LED columns.
    ATMEGA328P pins PD6 & 7 are SCL & SDA to DM163 pins DCK & SIN. DM163 pins IOUT0-23 are connected to LED RGB row pins
  • an M54564FP which drives the LED rows. ATMEGA328P pins PB0-4 & PD3,4 connect to M54564FP pins IN1-8. M54564FP pins OUT1-8 connect to LED pins VCC0-7
  • an EXTERNAL master Arduino device driving the LED colours via I2C/Wire (address 0x05)

This code is based on the "Colorduino" library/demo (https://www.itead.cc/blog/colorduino-schematic-and-demo-code) but simplified/clarified and with the addition of a simple I2C master/slave protocol.

Commands are a 1-byte transmission from the Master to the Chromaduino (Slave). Data is a 3-byte transmission. The Chromaduino has two RGB channel buffers of 3x8x8 bytes. One buffer (READ) is being read from to drive the LED display. The other buffer (WRITE) is being written to by the Master.

Commands:

0x00 sets the write pointer to the start of the WRITE buffer.

0x01 swaps the WRITE and READ buffers

0x02 takes the low 6 bits of the first 3 bytes in the WRITE buffer as GLOBAL scalars of the R, G and B values ("colour balance"). The default is 25, 63, 63. This downplays the intensity of Red to achieve a reasonable "White"

0x03 takes the 1st byte in the WRITE buffer as the TCNT2 value, provided the 2nd and 3rd bytes are 16 (clock freq in MHz) and 128 (clock divisor). TCNT2 drives the timer which updates the LED rows. The default is 99 for a frequency of 800Hz.
For a desired FREQ in Hz, TCNT2 = 255 - CLOCK/FREQ where CLOCK=16000000/128. Data: Triplets of bytes are written sequentially to the WRITE buffer as R, G & B (bytes beyond the buffer are ignored) Other transmissions are ignored

Request: Requesting a single byte returns the number of bytes written to the WRITE buffer

Demo: If #define'd, a demo will run after 5s if no wire data is received from the Master

Example: See ChromoduinoMaster.ino

Programming: Program the board by (for example) popping the ATmega chip off a Duemilanove and connecting GND-GND, 5V-VCC, RX(D0)-RXD, TX(D1)-TXD and RESET-DTR and programming the Duemilanove as normal. This will program the ATmega on the Funduino/Colorduino board.

v5 Mark Wilson 2016