FR: Only V-Score, no Tabs

[dartrax]

I tried to set "Spacing" to "0" as I hoped to get directly adjacted Boards with V-Cuts. The result looked awkward, with V-Cut only on the left side and a red line sitting somehow misplaced at the top...

[buganini]

You just found two issues

1. the red lines are conflicts but the offset is wrong

From https://jlcpcb.com/blog/technical-guidance-v-cut-panelization-standards, the tolerance is 0.4mm so I am not sure if 0 is a good setting, but still
2. I didn't handle zero-gap V-cuts or two very close V-cuts correctly.

[dartrax]

Yes 0.4 is better! Would be great if the tool would recognize such small offsets and connect the boards via V-Cut (aka making the "tabs" as long as the V-Cut)

[buganini]

Spacing=0 is not trivial to fix, since v-cuts positions are generated in tab building process. I think I'll add a minimum requirement for spacing and merge adjacent v-cuts.

[buganini]

V-Cuts merging is implemented, could you test it ?

[dartrax]

Looks great, I tested it with my current project and couldn't find any issue. Thank you!