-
|
maybe this is a stupid question. after searching for the answer in the wiki, I found nothing.(or didn't understand anything) How can I make it so that, for example, a disk drive connected to pins 2 and 3 plays a midi track, for example 3? The only option I figured out was to rearrange the pins. But it's long and inconvenient. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
You can change which drive plays which tracks using the Mappers at the bottom of the GUI. The drive attached to pins 2 and 3 is Sub-Address 1 (4/5 is sub-address 2, etc.). So if you wanted track 3 to play on sub-address 1, you would change "Condition" to |
Beta Was this translation helpful? Give feedback.
-
|
Thank you! |
Beta Was this translation helpful? Give feedback.
You can change which drive plays which tracks using the Mappers at the bottom of the GUI. The drive attached to pins 2 and 3 is Sub-Address 1 (4/5 is sub-address 2, etc.). So if you wanted track 3 to play on sub-address 1, you would change "Condition" to
c==3(only track 3) and change "Sub Address" to1(plays on the first drive).