-
-
Notifications
You must be signed in to change notification settings - Fork 503
/
config.txt
90 lines (67 loc) · 2 KB
/
config.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
#Modifcations to /boot/* files, will not be saved when powered on.
#Please ensure you edit from the DietPi-RamDisk location /DietPi/*
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1
# Set to 1 if your display has a black border of unused pixels visible
disable_overscan=1
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16
# uncomment to force a console size. By default it will be display's size minus
framebuffer_width=1280
framebuffer_height=720
# SDTV_MODES
#sdtv_mode=0
# Rotation
display_rotate=0
lcd_rotate=0
# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1
# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4
#-------RPi Camera Module-------
start_x=0
disable_camera_led=0
#-------GPU memory Splits-------
gpu_mem_256=16
gpu_mem_512=16
gpu_mem_1024=16
#-------Max USB Current -------
max_usb_current=1
#-------Disable Ram temp refresh every 500ms---------------
disable_pvt=1
#-------Disable Pi Splash screen on boot-------------
disable_splash=1
#-------Remove dedicated pll for PWM audio -------
avoid_pwm_pll=1
#-------SoundCard-------
#dtoverlay=none
dtparam=audio=off
#-------i2c-------------
dtparam=i2c_arm=off
dtparam=i2c1=off
i2c_arm_baudrate=100000
#-------spi-------------
dtparam=spi=off
#-------Overclock-------
temp_limit=65
initial_turbo=20
force_turbo=0
#over_voltage=0
#arm_freq=900
#core_freq=250
#sdram_freq=400
#arm_freq_min=700
#core_freq_min=250
#sdram_freq_min=400
#Note To Self, NEVER enable L2 cache, breaks most X based applications that were not compiled with L2 cache enabled.