Persist podman installation after firmware update

[amomchilov]

I had to re-install podman on my UDM Pro SE this morning after a firmware update.

Is there a way to make it persistent?

[an9rch1st]

podman, pi-hole and mcast relay containers were lost after upgrade yesterday.

[twojenski]

Same problem with my UDM Pro SE as well.
Latest update wiped out everything.

Was able put podman back on and run zerotier, without any problems.
When I tried to install pihole, it podman runs it, but I can not connect via HTTP to 10.0.5.3; ping 10.0.5.3 works.

Anybody have problems getting pihole to run again?

[amomchilov]

Anybody have problems getting pihole to run again?

I basically had to go through the installation steps all over again.

[twojenski]

Yea... not good.

[GigaBypass9876]

I had the same experience, reinstalling podman, removing dns and ip link, then running
/mnt/data/on_boot.d/10-dns.sh
/mnt/data/on_boot.d/05-install-cni-plugins.sh
/mnt/data/on_boot.d/custom_pihole_dote.sh
got it back up.

Has anyone with a UDMP-SE had any luck with utilities functioning after reboot using symlinks as suggested in #321 here?
#321 (comment)