PCB Size: 65mm x 65mm
This is a small power injector board for powering high-power fans, that require too much current to be connected directly into Fan ports on FanPico boards.
Board is meant to sit in between FanPico Fan ports and the high-power fans.
Fan Power Supply (12V) should be connected into one of the power inputs (only on input should be used at a time). Fans should be connected into "FAN" ports on the board, and cables connected from "FANCTRL" ports into FanPico (FAN ports) for fan control/monitoring.
Note, "FANCTRL" ports do not have voltage pin connected, so no power is drawn from the fan controller.
Install either F1 (polyfuse) or F2 (fuse holder for 5x20mm fuses), not both.
PCB should have at least 2oz copper thickness for adequate current carrying capacity.
- v1.1
- Make tracks thicker for ground pins on power connectors.
- v1.0
- Initial revision.