PCB drilling

Setup the GCode for drilling an already etched PCB in offset, orientation and scale.
The Camera must be setup already to go on with the following steps

1. Load the drill file (e.g. RS485_smd1.drd)

Load the file, e.g. by drag and drop

Remove offset, mark 1st teachpoint by clicking into 2D-view

2. Open Camera window and adjust GCode

Switch to 'Cam coord.', enable shape recognition if needed, 'Select filter set' to load other parameter set if recognition result is not ok.
Use mouse wheel to zoom into picture, press 'Space' on key board to hide 2D view

Press right mouse button, select 'Set actual pos. to marker pos.' to apply offset to cam coordinate system.

Select 2nd teachpoint in GUI 2D-view

Move to 2nd teachpoint in camera view and center the mark

Press right mouse button, select 'Compensate angle and scale' to rotate and scale GCode to match 2nd teachpoint.

Now the system is ready to start drilling