Crash

[userosos]

Version: 2.0.0-1
Build: slic3r++_2.0.0-1+UNKNOWN
Operating System: Windows
System Architecture: 64 bit
Windows Version: Windows 10 (build 17763), 64-bit edition
GL version: 4.6.0 NVIDIA 425.45
Vendor: NVIDIA Corporation
Renderer: Quadro P1000/PCIe/SSE2
GLSL version: 4.60 NVIDIA
I have crash everytime after i press slice! I can not use it! :(

[supermerill]

can i have your project? clic file-> save as instead of clicking slice. Then zip the file and drag-top here.
With it, i may be able to resolve the bug.

[MissingNoIOI]

It crashes for me too, I've narrowed it down to the support generation. With supports set to "nowhere" it slices fine, but once I enable them, doesn't matter if anywhere or just on the bed, it crashes during slicing. I've tried it with 3 models so far and all have crashed, here is one of them:
Bed_Direction.zip

Here are my settings:
Slic3r++.zip

I'm also on Windows 10 Pro (build 1803) 64bit, but I'm using an AMD graphics card

[MissingNoIOI]

Short addition, I tested it again in 1.42.0, it slices without a problem there, only 1.42.1 crashes