Changing full fan speed at layer causes crash

[Donpilkerton]

What happened?

I was trying to adjust the layer height at which the fan would run at full speed. Any value greater than 3 causes an error then a crash of the entire slicer if you hit ok on both dialog boxes. If you go back and change the value from 4 to 3 the error clears. Now this could be an issue on my end. I used super slicers last stable release and had no issues until I updated to the "Christmas" release. So if it is an issue on my end I apologize, as well as curious on how to make it work properly. Thanks!

Project file & How to reproduce

mammoth rapido fan mount 30x30.zip

Version

No response

Operating system

No response

Printer model

Voron 2.4 with ebb36 canbus, and stealthburner with cpap cooling.

[supermerill]

I think it's the same error as #4047 as i couldn't reproduce after fixing it.