Raspberry Pi 4 8GB + Sphero Modal RV01 [RV-507E] Not working

[gildardoperez]

I'm unable to run any of the getting_started examples on my Modal RV01.

I have tried:

1. Different RX and TX serial cables:

• 6 Ground
• 8 GPIO 14 (TXD)
• 10 GPIO 15 (RXD)

2. Both using ttyAMA0 and ttyS0 (By default, the RVR SDK uses the UART on /dev/ttys0 to communicate with RVR.)

sudo vim /boot/config.txt
add:
...
#dtoverlay=pi3-disable-bt
core_freq_min=500
enable_uart=1

3. Updating to Current firmware version

Current firmware version: 9.1.462, 9.2.482
MAC Address: 00-00-00-00-00-00
Manufacturing Date: 2019/9/14
Hardware Revision: 5

4. Install Sphero SDK GitHub repository for Raspberry Pi

git clone https://github.com/sphero-inc/sphero-sdk-raspberrypi-python.git
cd sphero-sdk-raspberrypi-python
./first-time-setup.sh

5. Used the "use-tty-symlinks" branch
sphero-sdk-raspberrypi-python/sphero_sdk/observer/client/dal/serial_observer_dal.py
...
def init(self, port_id='/dev/serial0', baud=115200):

...and still not able to run any of the examples, I only get the "Checking RVR firmware versions..."

/sphero-sdk-raspberrypi-python/getting_started/observer/driving/drive_target_slewing.py

Checking RVR firmware versions...
Getting default drive target slew parameters...
None
Driving to (0,0) at 0 degrees

Any other suggestions will be greatly appreciated. Thank you!

[OakAtsume]

Howdy!

I also had this issue and found a fix for it;

You need to access the Raspberry-PI via a GUI (e.g VNC/HDMI);
from there you have to open the "Raspberry Pi configuration"

and enable "Serial Port" and disable "Serial Console"

What I'm referring about, this image isn't mine but this is the place you need to look at and change the settings at.

Then simply give it a reboot and it should work now!

Please let me know if it does!