| layout | title |
|---|---|
documentation |
ZW15S - ZWave |
{% include base.html %}
This describes the Z-Wave device ZW15S, manufactured by Wenzhou MTLC Electric Appliances Co.,Ltd. with the thing type UID of enerwave_zw15s_00_000.
The device is in the category of Wall Switch, defining Any device attached to the wall that controls a binary status of something, for ex. a light switch.
The ZW15S supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
- Perfect Replacement for regular wall switch, 120VAC, 15Amp
- Wireless Z-Wave technology creates a mesh network for command and Manual and Remote ON/OFF control of any connected lighting and interoperability with other Z-Wave compliant controller and devices
- Manual and Remote ON/OFF control of any connected lighting and other electrical load
- Can be used for signal pole or 3- Way (Multi-location) with ZW3K Auxiliary Air-Gap Switch
- Air-Gap Switch feature meets UL requirement and disconnect power from load locally
- A blue LED illuminates when the load is off
Once switch paddle (top/button) is pressed, the device will enter into learn mode to accomplish inclusion or exclusion by controller.
Once switch paddle (top/button) is pressed, the device will enter into learn mode to accomplish inclusion or exclusion by controller.
The following table summarises the channels available for the ZW15S -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Switch | switch_binary | switch_binary | Switch | Switch |
Switch the power on and off.
The switch_binary channel is of type switch_binary and supports the Switch item and is in the Switch category.
The following table provides a summary of the 1 configuration parameters available in the ZW15S. Detailed information on each parameter can be found in the sections below.
| Param | Name | Description |
|---|---|---|
| 1 | LED State | LED State |
| Switch All Mode | Set the mode for the switch when receiving SWITCH ALL commands |
LED State
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Power on, LED off |
| 1 | Power on, LED on |
The manufacturer defined default value is 0 (Power on, LED off).
This parameter has the configuration ID config_1_1 and is of type INTEGER.
Set the mode for the switch when receiving SWITCH ALL commands.
The following option values may be configured -:
| Value | Description |
|---|---|
| 0 | Exclude from All On and All Off groups |
| 1 | Include in All On group |
| 2 | Include in All Off group |
| 255 | Include in All On and All Off groups |
This parameter has the configuration ID switchall_mode and is of type INTEGER.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The ZW15S supports 1 association group.
Association group 1 supports 5 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_BINARY_V1 | |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_CONFIGURATION_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 |
| Command Class | Comment |
|---|
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.