#Modifcations to /boot/* files, will not be saved when powered on. #Please ensure you edit from the DietPi-RamDisk location /DietPi/* # uncomment if you get no picture on HDMI for a default "safe" mode #hdmi_safe=1 # Set to 1 if your display has a black border of unused pixels visible disable_overscan=1 # uncomment the following to adjust overscan. Use positive numbers if console # goes off screen, and negative if there is too much border #overscan_left=16 #overscan_right=16 #overscan_top=16 #overscan_bottom=16 # uncomment to force a console size. By default it will be display's size minus framebuffer_width=1920 framebuffer_height=1080 # SDTV_MODES #sdtv_mode=0 # Rotation display_rotate=0 lcd_rotate=0 # uncomment if hdmi display is not detected and composite is being output #hdmi_force_hotplug=1 # uncomment to force a specific HDMI mode (this will force VGA) #hdmi_group=1 #hdmi_mode=1 # uncomment to force a HDMI mode rather than DVI. This can make audio work in # DMT (computer monitor) modes #hdmi_drive=2 # uncomment to increase signal to HDMI, if you have interference, blanking, or # no display #config_hdmi_boost=4 #-------RPi Camera Module------- start_x=0 disable_camera_led=0 #-------GPU memory Splits------- gpu_mem_256=128 gpu_mem_512=128 gpu_mem_1024=128 #-------Max USB Current ------- max_usb_current=1 #-------Disable Ram temp refresh every 500ms--------------- disable_pvt=1 #-------Disable Pi Splash screen on boot------------- disable_splash=1 #-------Remove dedicated pll for PWM audio ------- avoid_pwm_pll=0 #-------SoundCard------- #dtoverlay=none dtparam=audio=on #-------i2c------------- dtparam=i2c_arm=off dtparam=i2c1=off i2c_arm_baudrate=100000 #-------spi------------- dtparam=spi=off #-------Overclock------- temp_limit=75 initial_turbo=20 force_turbo=0 #over_voltage=0 #arm_freq=1200 #core_freq=400 #sdram_freq=450 #arm_freq_min=700 #core_freq_min=250 #sdram_freq_min=400 #Note To Self, NEVER enable L2 cache, breaks most X based applications that were not compiled with L2 cache enabled. dtoverlay=vc4-fkms-v3d boot_delay=0