Run on kernel 3.10.62

[MaciekJanicki]

Is it possible to use the driver on earlier linux kernel release, 3.10.62? As is written in readme it need the H5 uart, howerver it seems to work till hci_download_patch. Would appreciate any info at all. My hciattach output:

Realtek Bluetooth init uart with init speed:115200, final_speed:115200, type:HCI
UART H5
Realtek Bluetooth :Realtek hciattach version 2.5

Realtek Bluetooth :3-wire sync pattern resend : 1, len: 8

Realtek Bluetooth :Get SYNC Resp Pkt

Realtek Bluetooth :Get SYNC pkt-active mode

Realtek Bluetooth :3-wire config pattern resend : 1 , len: 10
Realtek Bluetooth :Get CONFG pkt-active mode

Realtek Bluetooth :3-wire config pattern resend : 2 , len: 10
Realtek Bluetooth :Get CONFG resp pkt-active mode

Realtek Bluetooth :H5 init finished

Realtek Bluetooth :config offset(f4),length(8)
Realtek Bluetooth :config baud rate to :4928002, hwflowcontrol:5f, 1
Realtek Bluetooth :config offset(27),length(1)
Realtek Bluetooth :config offset(fe),length(1)
Realtek Bluetooth :config offset(15b),length(4)
Realtek Bluetooth :config offset(1e3),length(1)
Realtek Bluetooth :Get config baud rate from config file:4928002
Realtek Bluetooth :Load FW OK
Realtek Bluetooth :RTK send HCI_VENDOR_READ_RTK_ROM_VERISION_Command

Realtek Bluetooth :Received reliable seqno 0 from card
Realtek Bluetooth :receive hci command complete event with command:1001

Realtek Bluetooth :Read RTK LMP version with Status:0
Realtek Bluetooth :gLmpVersion = 0x8723
Realtek Bluetooth :RTK send HCI_VENDOR_READ_RTK_ROM_VERISION_Command

Realtek Bluetooth :Received reliable seqno 1 from card
Realtek Bluetooth :receive hci command complete event with command:fc6d

Realtek Bluetooth :Read RTK rom version with Status:0
Realtek Bluetooth :rtk_hw_cfg.eversion = 1
Realtek Bluetooth :rtk_get_fw_project_id: opcode 0, len 1, data 1
Realtek Bluetooth :fw_ver 0x1e3ee40e, patch_num 2
Realtek Bluetooth :patch length is 0x5e90
Realtek Bluetooth :start offset is 0x4f00
Realtek Bluetooth :fw: exists, config file: exists
Realtek Bluetooth :baudrate in change speed command: 0x2 0x80 0x92 0x4

Realtek Bluetooth :Received reliable seqno 2 from card
Realtek Bluetooth :receive hci command complete event with command:fc17

Realtek Bluetooth :Change BD Rate with status:0
Realtek Bluetooth :final_speed 1500000

Realtek Bluetooth :hw flow control enable
Realtek Bluetooth :iEndIndex:96 iLastPacketLen:71 iAdditionpkt:4

Realtek Bluetooth :hci_download_patch tx_index:0 rx_index: -1

Realtek Bluetooth ERROR: patch timerout, retry:

Realtek Bluetooth :3-wire download patch re send:0