You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I couldn't find the content about the default transport boundary conditions in the manual.
For example, in section 2.9 of "FEHM_VERIFICATION", Test of Barometric Pumping Mechanisms,the model did not set the transport boundary of the surface. Is it set to zero solute-flux boundary by default?
What is the default processing method for FEHM if I do not set any boundary conditions for transport.
Looking forward to your reply.
Thank you!
The text was updated successfully, but these errors were encountered:
Hi,
I couldn't find the content about the default transport boundary conditions in the manual.
For example, in section 2.9 of "FEHM_VERIFICATION", Test of Barometric Pumping Mechanisms,the model did not set the transport boundary of the surface. Is it set to zero solute-flux boundary by default?
What is the default processing method for FEHM if I do not set any boundary conditions for transport.
Looking forward to your reply.
Thank you!
The text was updated successfully, but these errors were encountered: