-
-
Notifications
You must be signed in to change notification settings - Fork 138
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Some help needed with Valliant VCW376 without controller #22
Comments
the cause may be the missing controller on the one hand and on the other missing configuration file for the heater. please post the result of the following commands: |
Hi john, This is the result, any ideas???
done
pi@piServer /var/run $ |
Hi john, This is what i get when i enable 'raw' in ebusctl 2016-08-19 17:22:40.781 [bus notice] <aa |
this is just the raw output from the scan, so there is no extra relevant information in that one. |
Hi, i'm in need of some help. First i want to say i'm new to all of this so bare with me ;-)
I have a VCW376 heater and i have connected it to a ebus to usb converter(eservice) and connected everything to a PI2. Installed ebusd and started up service. So far so good i can read values with the 'r' command in ebusctl and response shows up ok.
What i was expecting that updates would come in to ebusd automatically. So if a value changed in de heater and these new values where to be submitted on the bus that i would be able to see these changes with the 'listen' command in ebusctl. But this is not the case. There are no updates. The only way i seem to get updates is when i configure a poll priority on de 'r' command.
So my question is, is this normal behaviour or is this due to the fact that i don't have a controller connected to my setup.
The text was updated successfully, but these errors were encountered: