Add a command for safety mode

[ioull]

I'm using the vtherm with a pilot wire.
It could be interressant to add a special command when vtherm goes in safety mode, for example eco mode.
It could be added in this configuration window:

Thanks a lot for this great plugin !

[jmcollin78]

Hello,

I understand the idea. The safety mode is not more than a pre-defined default power_percent (20% in my case). So it is not compatible with a preset selection but it is a small heating cycle.

[ioull]

OK Thanks for your answer, I didn't understood the safety mode very well ... My bad.
I thought that in safety mode, the heating is stopped !
a power percent is a good solution !

[jmcollin78]

Else in winter, the home will be so cold.