ercf.cfg

[gcode_macro CANCEL_PRINT]
description: Cancels the printer
rename_existing: CANCEL_PRINT_BASE
gcode:
  SET_FILAMENT_SENSOR SENSOR=encoder_sensor ENABLE=0
  END_PRINT
  TURN_OFF_HEATERS
  CLEAR_PAUSE
  CANCEL_PRINT_BASE

[gcode_macro RESUME]
rename_existing: BASE_RESUME
gcode:
    {% if printer.ercf.is_paused|int != 0 %}
        M118 You can't resume the print without unlocking the ERCF first.
        M118 Run ERCF_UNLOCK and solve any issue before hitting Resume again
    {% else %}
        {% if printer.ercf.clog_detection|int == 1 %}
            SET_FILAMENT_SENSOR SENSOR=encoder_sensor ENABLE=1
        {% endif %}
        {% set E = printer["gcode_macro PAUSE"].extrude|float %}
        # Prime
        {% if printer.extruder.can_extrude|lower == 'true' %}
          G91
          G1 E{E} F2100
          G90
        {% else %}
          {action_respond_info("Extruder not hot enough")}
        {% endif %}
        RESTORE_GCODE_STATE NAME=PAUSE_state MOVE=1
        G90
        BASE_RESUME
    {% endif %}

# The end_print macro is also called from CANCEL_PRINT. Includes
# ejcting filament from ERCF if called for.
[gcode_macro END_PRINT]
description: End print procedure, use this in your Slicer.
gcode:
  {% set unload = params.UNLOAD_AT_END|default(0)|int %}
  M118 Ending print
  SAVE_GCODE_STATE NAME=end_print_state
  _END_PRINT_BEFORE_HEATERS_OFF
  TURN_OFF_HEATERS
  _END_PRINT_AFTER_HEATERS_OFF
  _END_PRINT_PARK
  # Clear skew profile if any was loaded.
  {% if printer["gcode_macro RatOS"].skew_profile is defined %}
    SET_SKEW CLEAR=1
  {% endif %}
  {% if unload|int == 1 %}
    ERCF_EJECT
  {% endif %}
  # Steppers off
  M84
  # Part cooling fan off
  M107
  M117 Done :)
  RESPOND MSG="Done :)"
  RESTORE_GCODE_STATE NAME=end_print_state