Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

posts/2022-12-23-reenable_sidewinder_x2_runout_sensor/ #5

Open
utterances-bot opened this issue Dec 27, 2022 · 7 comments
Open

posts/2022-12-23-reenable_sidewinder_x2_runout_sensor/ #5

utterances-bot opened this issue Dec 27, 2022 · 7 comments
Labels
utterance Is an issue assigned

Comments

@utterances-bot
Copy link

Re-enable the Artillery Sidewinder X2 Filament-Runout Sensor | freakyDude's Blog

The post shows you how you can re-enable the stock Artillery Sidewinder X2 filament-runout sensor and configure with the Klipper3D printer firmware afterwards.

https://blog.freakydu.de/posts/2022-12-23-reenable_sidewinder_x2_runout_sensor/

Copy link

Thanks for the great article. I just plugged the filament sensor connector directly into the Z-Stop connector without making an extra adapter cable. This also works for me. Both have the same 3 PIN assignment.

@freakydude freakydude added the utterance Is an issue assigned label Dec 27, 2022
Copy link

I'm having a problem with filament section in WEB UI is always show empty state, but led on sensor is turning green and red when I insert or remove filament.

@freakydude
Copy link
Owner

That means you 5v and ground is connected correct. But you Mainboard or your software is not receiving the signal.

You should double check your hardware, your firmware and your octoprint or mainsail configurations

Copy link

Checked wires, and I made mistake with ground and 5v wire. When I switched position of that two wires, all started working as in article :) Now on to acceleration, input shaping and screen for my X2.
Thank You for great articles about klipper and everything about customizing SWX2 .

Copy link

Hello! has anyone used this function with a marlin firmware, specifically the latest one from freakydude? I am trying to make OctoPrint to use the z-stop connector but I am having trouble...

Copy link

Hi there, i tried to make my run out sensor work with klipper, worked almost...... it is recognized in mainsail, but the runout isnt, so when i take the filament out the led goes dark and thats it, filament back, led turns green.... any idea?

Greetings from Frankfurt/Main area
Karsten

Copy link

never mind!!!! just got the connection reversed..... now it works!

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
utterance Is an issue assigned
Projects
None yet
Development

No branches or pull requests

6 participants