I2C fix READ of zero bytes hardware hang (#2301)

The i2c peripheral will hang if a READ request is issued with a zero data length.  The peripheral
drops into a continuous timeout interrupt response.  The STOP command can not be set out to the I2C
bus. The SLAVE device correctly ACK'd the address byte, with READ bit set, it has control of the SDA
 pin.  The ESP32 send out the next SCL HIGH pulse but, since the SLAVE is in READ Mode, and the First
bit it is sending happened to be a ZERO, the ESP32 cannot send the STOP.  When it releases SDA during
the SCL HIGH, the pin does not change state.  The pin stays low because the SLAVE is outputing a LOW!
The ESP32 drops into a perminent WAIT state waiting for SDA to go HIGH (the STOP).

**esp32-hal-i2c.c**
* add databuff length checks to `i2cRead()` and `i2cWrite()`

cores/esp32/esp32-hal-i2c.c

@@ -1609,6 +1609,9 @@ i2c_err_t i2cFlush(i2c_t * i2c)
 }
 
 i2c_err_t i2cWrite(i2c_t * i2c, uint16_t address, uint8_t* buff, uint16_t size, bool sendStop, uint16_t timeOutMillis){
+    if((i2c==NULL)||((size>0)&&(buff==NULL))) { // need to have location to store requested data
+        return I2C_ERROR_DEV;
+    }
     i2c_err_t last_error = i2cAddQueueWrite(i2c, address, buff, size, sendStop, NULL);
 
     if(last_error == I2C_ERROR_OK) { //queued
@@ -1628,6 +1631,9 @@ i2c_err_t i2cWrite(i2c_t * i2c, uint16_t address, uint8_t* buff, uint16_t size,
 }
 
 i2c_err_t i2cRead(i2c_t * i2c, uint16_t address, uint8_t* buff, uint16_t size, bool sendStop, uint16_t timeOutMillis, uint32_t *readCount){
+    if((size == 0)||(i2c == NULL)||(buff==NULL)){ // hardware will hang if no data requested on READ
+        return I2C_ERROR_DEV;
+    }
     i2c_err_t last_error=i2cAddQueueRead(i2c, address, buff, size, sendStop, NULL);
 
     if(last_error == I2C_ERROR_OK) { //queued