Skip to content

Latest commit

 

History

History
executable file
·
78 lines (58 loc) · 2.66 KB

README.md

File metadata and controls

executable file
·
78 lines (58 loc) · 2.66 KB
Raw

DesignAids

Requirements:

1) Install LaTeX
2) Install SageMath
3) Configure LaTeX with SageMath
4) Install biber

Installation of Requirements:

1) LaTeX

   sudo apt-get install texlive-full

2) SageMath

   sudo apt-add-repository -y ppa:aims/sagemath
   sudo apt-get update
   sudo apt-get install sagemath-upstream-binary

3) Configure LaTeX with SageMath
  
   http://www.hpc.wm.edu/sciclone/documentation/software/math/sage-5.1/html/en/installation/sagetex.html
   https://amrit3701.wordpress.com/2015/07/19/configure-sagetex-sty-or-make-sagetex-known-to-tex/            
                                             
4) biber
   
   sudo apt-get install biber

References: LaTeX, SageMath, biber

To run:

1) pdflatex main.tex
2) biber main
3) sage main.sagetex.sage
4) pdflatex main.tex

To create pdf from make:

make

After creating pdf you can run the below command to view pdf:

make view

Clean all the unnecessary file which are made by make:

make clean

Documentation:

This Docmentation include procedure of adding new chapter in this project. To add new chapter, just create new .tex file with the name of chapter and place it in input/ folder, after that call it in main.tex. Macros are defined in usepackage.tex, use them to write Fig., Equation, Chart, Table, Fe250, Fe415, Fe500, Given:, Requried:, Solution: etc. There are also macros for various units such as kN, kNm, mm etc., use them to write units instead of manual typing. Example environment is also defined in usepackage.tex, use it to write Numeric example in chapters.

Style of writing Figure, Equation, Chart, Table etc., must be consistant for whole book. It should be Fig(1.1), Equation(1.1), Chart(1.1), Table(1.1) etc. And Equation no., Chart no., Table no., Fig no. should come by referencing the label.

Table should be created from .csv file. To create table, write csv file and save it with abbrivation of chapter's name inside the input/csv.

To add bibliography, there is only one DesignAids.bib file for whole book, citations will come from this .bib file. You can add new entries in .bib if you needed. Citation such as \citetitle{is4561964} and \citetitle{is4562000} are coming from DesignAids.bib. Use \citetitle{is4561964} and \citetitle{is4562000} for oldCode and newCode (for Code also) respectively.