Wired Xbox 360 Controller USB-C Mod - Rev 1.4

Diy USB-C conversion for wired controllers

Purchase the PCB on OSHPark

Front

Back

Installed on the board

Port

BOM:

TYPE-C-31-M-12

1x4 2.54mm Pitch header

5.1K 0603 Resistor x 2 (Only required for usb-c to usb-c connections)

3D Printed bezel

Assembly

1: Solder the 5 pin header & usb-c port to the pcb

2: Desolder the 5 pin header on the 360 controllers

3: solder the other side of the 5 pins on the pcb to the board (You might have to bend the pins slightly to line up the port)

4: install the 3d printed bracket

5: screw the controller back together

Changelog:

1.4:

• Replaced the usb c receptacle with TYPE-C-31-M-12, this may require some additional modification of the 3d printed bezel, but should make the adapters last way longer.