Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Program button can't be pressed using the current 3d printed case #26

Open
bmidgley opened this issue Feb 19, 2019 · 2 comments
Open

Program button can't be pressed using the current 3d printed case #26

bmidgley opened this issue Feb 19, 2019 · 2 comments
Milestone
data-sharing

Comments

@bmidgley
Copy link
Owner

This is a hardware bug! I'll get exact measurements so we can print a pinhole in the right spot and use a pin to hit this button.

I've tried this out and found I broke the microusb connection to the board. So we will need to be sure the board is both connected solidly to the faceplate and also add a little loop in the usb cable so if it does wiggle, it won't put pressure on the connector.
@bmidgley bmidgley assigned bmidgley and unassigned bmidgley Feb 19, 2019
@bmidgley bmidgley added this to the data-sharing milestone Feb 19, 2019
@bmidgley
Copy link
Owner Author

I measure 72.5mm from the left side and 22mm from the top hits the center of the button. We should have a hole that is 1 to 1.5mm diameter. Should be big enough to get a sharp pin in but not so big that we might miss the button.

@bmidgley
Copy link
Owner Author

image

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
data-sharing
Development

No branches or pull requests
1 participant
@bmidgley