[SUPPORT] Tunnel does not connect after upgrading from 1.0.7 to 2.0.5

[Quitomm]

In the new version, I configured exactly the same configuration as in the old version of the application.
When click Enable, it says in the logs(AppData/Local/com.tunnl.to/logs) that the tunnel is running, but nothing works. There are no logs in the application itself, and the Enable button continues to be blocked, as if the program is still trying to connect and so on endlessly

[brendanosborne]

Can you take a look at the tunnel config file that is generated by the old app and compare it to the new one? You'll need to:

1. Uninstall TunnlTo 2.0.5
2. Uninstall Wiresock
3. Install version 1.0.7 of TunnlTo.
4. Connect to the tunnel.
5. After it connects, Disconnect.
6. Take a copy of the config file generated in C:\Users\[YOUR USERNAME]\AppData\Local\TunnlTo\tunnel.conf
7. Install TunnlTo 2.0.5
8. Connect to the same tunnel with the same settings.
9. Compare the config file located in the same location. The only difference should be the two "#" comments at the top.

If you post any config details here please ensure you remove any sensitive details such as the keys and IP endpoint addresses.

[brendanosborne]

@Quitomm Did you get around to trying the troubleshooting steps?