BB2 Screw/Nut on Wishbone sometimes causes issues if it touches the AS5311 board

[nicholasqle]

Describe the bug
On one magnet sensor used, I found that there was odd behavior if the nut was touching the board. The dendrometer would be stuck on but would not function. The red lights on the feather board and the Hypnos board would all be illuminated, except for the status LED. When this happens, the device will be stuck like this and is not visible in Arduino IDE until it is reset. The device will continue working normally after the reset and the wishbone is moved off of the magnet sensor.
Hardware in Use
A list of all hardware currently in use
Blueberry dendrometer 2
Magnet sensor

To Reproduce
Steps to reproduce the behavior:

1. Position wishbone so the nut is touching the board.
2. Plug magnet sensor into Dendrometer.
3. Power on Dendrometer

Expected behavior
The device should be able to function normally. Perhaps better insulation on the magnet sensor is needed to prevent shorts?