fanuc-hmi-jointstreaming

Alpha implementation of joint position streaming via HMI

Setup

Requirements: Fanuc options:

• R553 HMI Device (SNPX) System variables:
• $SNPX_PARAM.$NUM_MODBUS = 2
• $SNPX_ASG[76]:
  • $ADDRESS = 16300
  • $SIZE = 2
  • $VAR_NAME = $SNPX_ASG[80].$ADDRESS
  • $MULTIPLY = 1.000
• $SNPX_ASG[77]:
  • $ADDRESS = 16302
  • $SIZE = 2
  • $VAR_NAME = $SNPX_ASG[80].$SIZE
  • $MULTIPLY = 1.000
• $SNPX_ASG[78]:
  • $ADDRESS = 16304
  • $SIZE = 40
  • $VAR_NAME = $SNPX_ASG[80].$VAR_NAME
  • $MULTIPLY = -1.000
• $SNPX_ASG[79]:
  • $ADDRESS = 16344
  • $SIZE = 2
  • $VAR_NAME = $SNPX_ASG[80].$MULTIPLY
  • $MULTIPLY = 0.000 IO:
• DO[3] should be mapped to UI[6]
• DO[4] should be mapped to UI[2]
• DO[5] should be mapped to UI[5]
• DO[6] should be mapped to UI[4]

I implemented these mappings via a MemPort (rack 0, slot 0, start 1)

• DI[118-120] and DI[185] should be mapped to safety scanner inputs so the system can monitor when robot is going to be halted and stop streaming.

System->Config:

• 7: Enable UI signals: True
• 8: START for CONTINUE only: False
• 9: CSTOPI for ABORT: TRUE
• 10: Abort all programs by CSTOPI: True
• 43: Remote/Local setup: Remote

Then setup controller to run program using Other option (defaults to PNS). Setup->Prog Select->Prog Select Mode.

Demo

Launch the system using roslaunch fanuc_driver fanuc-drivers.launch robot_ip:=<IP address>

After the system launches, there is a demo script that demonstrates position streaming. The script first moves a 6-axis robot to [0, 0, 0, 0, 0, 0], and then moves J1 in a sine wave pattern for 10 seconds. Run the motion demo script using rosrun fanuc_driver motion_demo

Notes

This is an alpha implementation of joint position streaming using HMI, thus it is lacking in some features that would be needed in a production environment. For example, the current streaming implementation does not implement any feedback from joint positions, it just steps through the trajectory in time and interpolates points to send as the next setpoint. The time-scaling factor can be reduced from 1 if something is causing the robot to run slower than the trajectory (E-stop event, operator speed override), but if the robot momentarily stops for whatever reason while the time scaling factor remains at 1, there could be jumps in motion, potentially through in an obstacle in environment that the trajectory would have navigated around.