What slicer to select for Orca Slicer ?

[sejtam]

I am using Orcaslicer 1.6.3 (which is based on BambooSlicer, which is based ... on Prusaslicer)

Do I enable automatic slicer config detection?

How outdated isn the v0.4 set of guides? ( I have [Octolapse 0.4.3])

Quite a few options/settings referenced in there cannot be found
for my printer (anycubic Mega S i3, with Klipper installed)

Do I need a different printer setting for Klipper?

I cannot find any 'Build Volume and Origin' settings,
The G90/G91 influences Extruder setting at all in the firmware settings, or rather these all vanish when. the
server updates the printer profile?

[RemyLebeau]

Same issue here. I'd love to keep using optolapse with orca slicer, but I without doing a full manual calibration, it seems out of the question!

[RemyLebeau]

I'm using a Sovol SV06 with Marlin f/w