My build

[cleggers21]

My build using 110mm / 4” soil pipe fittings.
I used 2 end caps, one I cut two sections out to allow the heat from the Pi5 to keep the dome warm.
The caps just push fit into the pipe coupler and hopefully provide a waterproof seal.
I’m using a RPi power board which converts an old 19v laptop power brick to 5v X 5A enabling a long power lead. I tried a few Buck converters but none gave a consistent output which the RPi5 requires.
I 3D printed a support for the RPi to keep it vertical as it overheated if left horizontal.
The black clip-on is ideal for fixing the camera to a wall.

The dome is 100mm with a 20mm flange.
I also used the longer camera connector which helped when assembling.

[EricClaeys]

I like the shiny outside.
Let us know how well it works outside.

[cleggers21]

First light and there was moister inside the dome so I’ve ordered a 100/110 mm rubber seal.
🦭